They mount via a barrel nut by the chamber, and that’s it. They are called “free-float” because they don’t actually ever touch the barrel. Step 5: Remove the Charging Handle and BCGįree-float handguards are more secure and provide better control and durability, but they’re also more difficult to remove. After the trigger releases, you can ease the hammer back with your thumb to prevent damage. I would recommend holding the hammer with your thumb when you pull the trigger so it doesn’t jump forward and smack into the top of the trigger guard. If you pull the trigger, the hammer will jump forward, which gives you better access to clean the entirety of the trigger mechanism. The trigger should be in the “not-fired” position, which means the hammer will be leaning back. The trigger has two positions – fired and not fired. For cleaning, all you should need to do is oil the spring occasionally. Pull the buffer and spring out of the buffer tube and set them aside. Simply push down on that pin until the buffer pops out. There should be a small pin at the bottom that’s holding the buffer in. Inside there is a metal bolt (the buffer) and a long spring. If you’re unsure what these are, look for the metal circle inside the stock tube of the upper receiver that is now visible. With the upper receiver and lower receiver separated, you can now remove the buffer and buffer tube spring. Once that’s been verified, make sure the safety is on anyway. This safety check should entail pulling the charging handle back and visually inspecting the chamber to ensure a round is not presenton your AR-15 rifle. Perform a safety check to ensure that the rifle is not loaded. For Basic Cleaning: Step 1: Clear the Rifle, Safety Checkīefore you disassemble your AR-15, ensure it is unloaded and clear of any ammunition. If you aren’t seeing what I’m describing, then you may want to check out the owner’s manual if you have it or see if there are videos on YouTube with instructions on your specific rifle. Some rifles may have different parts or operate differently. It’s important to note that not all AR-15s are built the same way. Note: This Is Based on Mil-Spec, Yours Might Be Different Disassembling an AR-15: A Step-By-Step Guide To remove the handguard, first remove the gas block and tension screws, loosen the locking ring, slide the handguard off the barrel, and then remove the barrel nut. To disassemble the BCG, pull out the cotter pin, and remove the firing pin, bolt cam pin, bolt, and extractor pin. If you want to do a more in-depth clean or have other maintenance you want to do, you can take things down further. Remove the buffer and buffer spring, engage the trigger, and remove the charging handle and bolt carrier group (BCG) from the upper receiver. Then, pop out the takedown pins and separate the upper and lower receiver. To disassemble an AR-15 for cleaning, first clear the rifle and perform a safety check.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |